1. Home
  2. Login
  3. View Cart
  4. Checkout

Audio Technica AT-OC9XSH Dual Moving Coil Cartridge with Nude Shibata Stylus

Audio Technica AT-OC9XSH Dual Moving Coil Cartridge with Nude Shibata Stylus

Price: 570.00

preorder

Pre-order for delivery from mid-July
{DESCRIPTION}
Since its introduction more than 30 years ago, Audio-Technica's pioneering moving coil OC9 cartridge series has been prized by demanding vinyl listeners and professional critics alike for its musical transparency, expression of sound and precise construction.
The AT-OC9XSH cartridge has a Shibata diamond profile originally designed for Quadraphonic replay offering a depth of sound, combined with high frequency response that has to be heard to be believed, detail like never before experienced and limiting inner groove distortion. The Shibata profile provides for low record and stylus wear and the higher dynamic compliance enables this cartridge to be used on low to medium mass tonerarms:
• Nude Shibata stylus and boron cantilever
• A neodymium magnet and permendur yoke for increased magnetic energy
• Threaded inserts in the cartridge body to enable the cartridge to be mounted on to the headshell or integral tonearm with just two screws
• Aluminium body mimimises unwanted vibration for reduced resonance and a superior audio reproduction
• Pure Copper by OHNO Continuous Casting (PCOCC) process is used for the coils to achieve the purest signal possible
{SPECIFICATION}
TypeMoving Coil (MC)
MountingStandard 1/2" centers / threaded inserts
Size17.3(H) x 16.8(W) x 25.7(L)mm
Weight 7.6 g
StylusShibata 2.7 x 0.26 mil, nude square shank
Cantilever 0.28mm nude boron, 20° Vertical tracking angle
Tracking Force 1.8 - 2.2 g (2.0 g Standard)
Output Voltage 0.4 mV (1kHz, 5cm/s)
Frequency Response20Hz-47kHz
Channel Balance1.0 dB (1kHz)
Channel Separation 27 dB (1kHz)
Coil Impedance12 Ohms (1kHz)
DC Resistance12 Ohms
Coil Inductance25 µH (1kHz)
Static Compliance20 µm/mN (cm/dyne)
Dynamic Compliance16 µm/mN (100Hz) (cm/dyne)
Wire Used for CoilPCOCC (Copper by Ohno Continuous Casting Process)
Recommended Load ImpedanceMin 100 Ohm
Accessories Included1 non magnetic screw driver,1 brush
4 pairs of mounting screws: 5mm, 8mm,10mm,12mm, 2 washers
1 plastic protector

Recently Viewed