1. Home
  2. Login
  3. View Cart
  4. Checkout

Audio Technica AT-OC9XSL Dual Moving Coil Cartridge with Special Line Contact Stylus

Audio Technica AT-OC9XSL Dual Moving Coil Cartridge with Special Line Contact Stylus

Price: 660.00

preorder

Pre-order for delivery from end-July
{DESCRIPTION}
Since its introduction more than 30 years ago, Audio-Technica's pioneering moving coil OC9 cartridge series has been prized by demanding vinyl listeners and professional critics alike for its musical transparency, expression of sound and precise construction.
The AT-OC9XSL cartridge replacement for the AT-OC9ML Mk III has the Special Line Contact diamond profile as featured in the flagship ART1000, offering the ultimate in sonic reproduction with a sense of space and realism to all instruments that few other configurations can achieve. The Special Line Contact profile provides for low record and stylus wear and the higher dynamic compliance enables this cartridge to be used on low to medium mass tonerarms:
• Nude Special Line Contact stylus and boron cantilever
• A neodymium magnet and permendur yoke for increased magnetic energy
• Threaded inserts in the cartridge body to enable the cartridge to be mounted on to the headshell or integral tonearm with just two screws
• Aluminium body mimimises unwanted vibration for reduced resonance and a superior audio reproduction
• Pure Copper by OHNO Continuous Casting (PCOCC) process is used for the coils to achieve the purest signal possible
{SPECIFICATION}
TypeMoving Coil (MC)
MountingStandard 1/2" centers / threaded inserts
Size17.3(H) x 16.8(W) x 25.7(L)mm
Weight 7.6 g
StylusSpecial Line Contact 1.5 x 0.28 mil, nude rectangular shank
Cantilever 0.28mm nude boron, 20° Vertical tracking angle
Tracking Force 1.8 - 2.2 g (2.0 g Standard)
Output Voltage 0.4 mV (1kHz, 5cm/s)
Frequency Response20Hz-50kHz
Channel Balance0.5 dB (1kHz)
Channel Separation 28 dB (1kHz)
Coil Impedance12 Ohms (1kHz)
DC Resistance12 Ohms
Coil Inductance25 µH (1kHz)
Static Compliance22 µm/mN (cm/dyne)
Dynamic Compliance18 µm/mN (100Hz) (cm/dyne)
Wire Used for CoilPCOCC (Copper by Ohno Continuous Casting Process)
Recommended Load ImpedanceMin 100 Ohm
Accessories Included1 non magnetic screw driver,1 brush
4 pairs of mounting screws: 5mm, 8mm,10mm,12mm, 2 washers
1 plastic protector

Recently Viewed